sE Electronics sE4400a Large Diaphragm Multipattern Condenser Microphone

Includes microphone, original packaging, roadcase, thread. Craddle not included Hand-crafted with the highest attention to detail, built with a roadworthy die-cast all-metal housing, metal switches, and rugged spring steel wire mesh grille that can take a beating during day-to-day tour life. The sE4400 appeals with its down-to-earth elegance, offering discrete electronics prioritizing the features you really need. Hand-crafted true condenser capsule individually tuned in our own factory Classic vintage sound and all-metal housing Switchable pickup patterns, cardioid, omnidirectional, figure-eight, and hypercardioid Innovative close-miking shockmount 40 / 80 Hz bass-cut filters and -10 / -20 dB pads Capsule: Hand-crafted 1" Gold-sputtered True Condenser Diaphragm: Gold-sputtered mylar Electrical impedance: 22 Ohms Connectivity: 3-pin male XLR connector Powering: 48V Phantom Power (P48 according to IEC 61938) Polar patterns: Cardioid, Hypercardioid, Omni-directional, Figure-8 Frequency range: 20 Hz - 20 kHz Sensitivity: 25 mV / Pa (-32 dBV) Max SPL: 137 / 147 / 157 dB (0/10/20 dB Attenuation pad - 0.5% THD) Equivalent noise level: 13 dB(A) Signal to noise ratio: 81 dB Low-cut filter: 40 / 80 Hz, 6 dB/Oct, switchable Attenuation pad: 10 / 20 dB, switchable Mic weight: 290 g (10.23 oz.) Mic length: 146 mm (5.75 in.) Mic width: 58 mm (2.32 in.) Mic diameter: 29 mm (1.10 in.) Tested and under warranty. Every preloved item is serviced, repaired if needed, and tested by our techs before it goes on sale. Used gear comes with our warranty: 3 months for electrical faults and 6 months for structural faults. It excludes misuse, neglect, unreasonable wear and service items such as strings and batteries. It's on top of your rights under the Australian Consumer Law. --- Southside Guitars Brisbane 16 Chrome Street Salisbury, QLD 4107 Australia